Hyundai Tucson: Interior rearview mirrors / Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the handheld transmitter 1 to 3 inches away from the HomeLink® surface.
3. Press and hold the handheld transmitter button. The HomeLink® indicator light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash rapidly, release both buttons.
5. Press and hold the just-trained HomeLink® button and observe the red Status Indicator LED. If the indicator light stays on constantly, programming is complete and your new device should activate.
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button.
Activation will now occur for the trained device (i.e. garage door opener, gate
operator, security system, entry door lock, ho ...
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash-after 20 seconds.
...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Automatic climate control system
To defog inside windshield
1. Set the fan speed to the desired position.
2. Select desired temperature.
3. Press the defroster button ().
4. The air conditioning will turn on according to the detected ambient temperature
and outside (fresh) air position will be selected automatically.
If th ...
Hyundai Tucson (LM) 2010-2015 Service Manual: TJ Joint Repair procedures
Removal
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
1.
Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) ...
