Hyundai Tucson: Mirrors / Interior rearview mirrors
Before you start driving, adjust the rearview mirror to the center on the view through the rear window.
WARNING
Make sure your line of sight is not obstructed. Do not place objects in the rear seat, cargo area, or behind the rear headrests which could interfere with your vision through the rear window.
WARNING
To prevent serious injury during an accident or deployment of the air bag, do not modify the rearview mirror and do not install a wide mirror.
WARNING
NEVER adjust the mirror while driving. This may cause loss of vehicle control resulting in an accident.
- Day/Night rearview mirror (if equipped)
- Electric chromic mirror (ECM) (if equipped)
- Blue Link® center (if equipped)
- Electric chromic mirror (ECM) with compass and HomeLink® system (if equipped)
- Compass function
- Rolling code programming
- Standard programming
- Gate operator & Canadian programming
- Operating HomeLink®
- Reprogramming a single HomeLink® button
- Erasing HomeLink® buttons
- Electric chromic mirror (ECM) with HomeLink® system, compass and Blue Link® (if equipped)
Mirrors
...
Day/Night rearview mirror (if equipped)
Make this adjustment before you start driving and while the day/night lever is
in the day position.
Pull the day/night lever toward you to reduce headlight glare from vehicles behind
you during ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Fuel Filler Cap Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which seals the fuel
filler. After the gasket on the fuel filler cap and the filler neck
flange contact each other, the ratchet produces a loud clicking noise
indicating ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Ultrasonic Sensor Repair procedures
Removal
1.
Remove the rear bumper.
(Refer to the BD group - "Rear bumper")
2.
Disconnect the sensor connector (A) inside the rear bumper.
3.
Pull out the sensor (A) by opening the sensor holder (B) out.
Installation
1.
Connect the connector, and then reassemble the sensor.
2.
I ...
