Hyundai Tucson: Interior rearview mirrors / Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting. Continue to press the Integrated HomeLink® Wireless Control System button (note steps 2 through 4 in the Standard Programming portion of this document) while you press and re-press ("cycle") your handheld transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds upon successful training.
Standard programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons, HomeLink®
Channel 1 and Channel 3 Buttons, until the indicator light begins ...
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button.
Activation will now occur for the trained device (i.e. garage door opener, gate
operator, security system, entry door lock, ho ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Service Tools
Tool (Number and Name)IIIustrationUse09568-34000 Ball joint remover09546-26000 Strut spring compressorCompression of coil spring09568-4R100Lower arm ball joint removerRemoval of front lower arm from front axle
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Console Repair procedures
Replacement
[M/T]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Use a plastic pane ...
