Hyundai Tucson: Interior rearview mirrors / Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button.
Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time.
Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting.
Continue to press the Integrated HomeLink® Wireless Control System button (note
steps 2 through 4 in the Standar ...
Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these
steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has
been completed.
2. When th ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Ultrasonic Sensor Repair procedures
Removal
1.
Remove the rear bumper.
(Refer to the BD group - "Rear bumper")
2.
Disconnect the sensor connector (A) inside the rear bumper.
3.
Pull out the sensor (A) by opening the sensor holder (B) out.
Installation
1.
Connect the connector, and then reassemble the sensor.
2.
I ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Coil Spring Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
2.
Support the rear lower arm (A) with a jack as shown i ...
