Hyundai Tucson: Engine Control System / ETC (Electronic Throttle Control) System Repair procedures
Throttle Position Sensor (TPS)
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to “Specification”
|
|
ETC Motor
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the ETC module connector. |
3. |
Measure resistance between the ETC module terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification”
|
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the resonator and the air intake hose
(Refer to Engine Mechanical System - “Intake And Exhaust System”) |
3. |
Disconnect the ETC module connector (A). |
4. |
Disconnect the coolant hoses (B). |
5. |
Remove the installation bolts (C), and then remove the ETC module from the engine. 
|
• |
Install the component with the specified torques. |
• |
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing. |
|
1. |
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.2 lb-ft)
|
|
ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1. |
Hold the ignition key or the start button at th IG ON position during 5 seconds. |
2. |
Turn ignition swich OFF and then start the engine. |
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module. |
Circuit Diagram
(M/T)
(A/T)
...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog si ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Adjustment
Description
The friction material inside the coupling will degrade over
time. Therefore, corresponding compensation values must be referenced
and entered after replacing the controller or the coupling.
Compensation Requirement and Procedure
1.
Simultaneous replacement of 4W ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Starter Relay Repair procedures
Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
4.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalValueMeasure30 - 871Mx or HigherIf there is continuity, replace the relay.
...