Hyundai Tucson: AVN System / External Amplifier Repair procedures

Removal
External Amplifier
1.
Remove the rear right luggage side trim.
(Refer to Body - "Interior Trim")
2.
Remove the external amplifier (B) after disconnecting the connectors (A) and loosening the mounting nuts.

Installation
External Amplifier
1.
Install the external amplifier after connecting the connector.
2.
Install the interior trim.
   
-
Make sure the speaker and related connectors are plugged in properly.
External Amplifier Components and Components Location
Components Connector Pin Information No.Connector A (26 pin)Connector B (16 pin)Connector C (12 pin)1Battery +Right surround speaker +Rear right door +2Battery +Left surround speaker +Rear left do ...

Roof Antenna Components and Components Location
Components ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Ignition Coil Description and Operation
Description An ignition coil is an induction coil in an engine's ignition system which transforms the battery's low voltage to the high voltage needed to create an electric spark in the spark plugs to ignite the fuel. Coils have an internal resistor while others rely on a resistor wire or ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Accelerator Position Sensor (APS) Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power ...

© 2010-2024 www.htmanual.net