Hyundai Tucson: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Remove the rear-LH wheel, tire, and the inner wheel house.

2.	Disconnect the fuel filler hose (A) and the ventilation hose (B).

3.	Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

4.	Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).

Installation

Install in the reverse order of removal.

Filler-neck assembly bracket installation nut :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Fuel Pump Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Remove the rear seat. (Refer to Body - “Seat”) ...

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B), th ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting SymptomSuspect areaEngine will not start or hard to startVapor hose damaged or disconnectedEngine hard to startMalfunction of the Purge Control Solenoid ValveRough idle or engine stallsVapor hose damaged or disconnectedMalfunction of the PCV valveRough idleMalfunction of the Eva ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Flex Steer Schematic Diagrams
Part Circuit Diagram ...