Hyundai Tucson: Fuel Delivery System / Accelerator Pedal Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation nuts (B), the bolt (C) and then remove the accelerator pedal module.

Installation

Install in the reverse order of removal.

Accelerator pedal module installation nut:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

Accelerator pedal module installation bolt:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly Repair procedures

Removal 1. Remove the rear-LH wheel, tire, and the inner wheel house. 2. Disconnect the fuel filler hose (A) and the ventilation hose (B). 3. Open the fuel filler door and unfasten the fil ...

Delivery Pipe Repair procedures

Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Door Repair procedures
Replacement Front Door Trim Replacement • When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Put on gloves to protect your hands. 1. Using a screwdriver or ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Propeller Shaft Components and Components Location
Components 1. Front propeller shaft2. Center bearing bracket3. Rear propeller shaft ...