Hyundai Tucson: Engine Control System / Fuel Pressure Control Valve Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Pressure Control Valve Repair procedures

Inspection

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the fuel pressure regulator valve connector.

3.	Measure resistance between the fuel pressure regulator valve terminals 1 and 2.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

(Refer to Fuel Delivery System - "High Pressure Fuel Pump”)

Installation

(Refer to Fuel Delivery System - "High Pressure Fuel Pump”)

Fuel Pressure Control Valve Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Canister Close Valve (CCV) Description and Operation

Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosph ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: TJ Joint Repair procedures
Removal • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new one. 1. Remove the Front Driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications Tightening Torques ItemsN.mKgf.mlb-ftTransfer assembly mounting bolts60.8~65.76.2~6.744.8~48.54WD ECM mounting nuts9.8~11.81.0~1.27.2~8.7Coupling assembly mounting bolts56.9~64.75.8~6.642.0~47.7Propeller shaft mounting bolts49.0~68.65.0~7.036.2~50.6Transfer oil drain plug39.2~ ...