Hyundai Tucson: Steering wheel / Heated Steering wheel Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Steering System / Steering wheel / Heated Steering wheel Repair procedures

Repair Procedures

Measure a resistance of NTC and Heated pad.

A.	NTC resistance(Black / Yellow, Black) - 9.0 kx ~ kx (25°C)

B.	Heated pad resistance (Yellow, Black) - 1.4 ~ 1.8 x ± 10%

Measure a temperature.

A.	The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute

B.	The temperature of wheel surface grip must keep 38°C ± 4°C after 25 minute

C.	At that time switch on, all measure point (1~8)

Removal

[Heated steering switch]

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the crash pad side switch assembly. (Refer to Body - "Crash Pad Lower Panel")

3.	Check the continuity between the switch terminals as the heated steering switch is engaged.

Heated Steering wheel Schematic Diagrams

Schematic Diagram 1. Teminals 2. Teminal function ConnectorNoSignalColorA1GNDBlack2BattaryRed3SwitchWhite4LEDGreen ConnectorNoSignalColorB1HeaterYellow2NTCBlack/Red3GNDBlack 3. S ...

Electric Power Steering

...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Output Speed Sensor Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body") 2. Disconnect the input & output speed sensor conn ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil hydraulic Motor(Actuator) Description and Operation
Description The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil pressure. The pressure engages a multiple disk clutch to transfer torque to the rear wheels. The torque to the rear wheels varies according to the pressure on the clutch. ...