Hyundai Tucson: Indicators And Gauges / Instrument Cluster Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Indicators And Gauges / Instrument Cluster Description and Operation

Description

ECO driving system

This system is designed to encourage eco-driving by providing real-time feedback to the driver.

The ECO indicator light assists you to drive in the most economical way.

The green indicator comes on when you drive with high fuel efficiency.

The fuel efficiency depends on driver's driving habit and road condition.

The system stops operation when the transaxle is in the P,R,N position or sports mode, or instantaneous fuel consumption mode is selected.

ECO indicator ON/OFF

1.	ECO indicator system stops operation when instantaneous fuel consumption mode is selected.

ECO indicator light is always OFF when driver select the "ECO OFF" mode pushing the "Trip" button.

A.	Set the main LCD display to "ECO ON" pushing "Trip" button as below picture.

B.	And then set the "ECO OFF" pushing "Trip" button more than 1 second as below picture. In this option, ECO indicator light does not operate any trip mode.

Instrument Cluster Schematic Diagrams

Circuit Diagram (1) Circuit Diagram (2) Massage Flow Diagram ...

Instrument Cluster Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A). [LHD] [RHD] 3. Remove the cluster fascia lower panel (A). [LHD] [RHD] 4. Remove t ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Seat Belt – Passenger’s 3-point system with combination locking retractor
This type of seat belt combines the features of both an emergency locking retractor seat belt and an automatic locking retractor seat belt. Combination retractor type seat belts are installed in the rear seat positions to help accommodate the installation of child restraint systems. Although a ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps: 1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the handheld transmitter 1 t ...