Hyundai Tucson: Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the MAPS at idle and IG ON.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.

Manifold absolute pressure sensor installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Intake Air Temperature Sensor (IATS) Description and Operation

Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of t ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Wheel Transfer Assembly Repair procedures
Removal 1. Remove the following items; A. Sub frame assembly (Refer to Suspension System - "Sub Frame") B. Drive shaft assembly. (Refer to Driveshaft and axle - "Front Driveshaft ") 2. Remove the propeller shaft (A). Tightening torque : 49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb- ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine ...