Hyundai Tucson: Seat Belt / Rear Seat Belt Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body (Interior and Exterior) / Seat Belt / Rear Seat Belt Repair procedures

Replacement

Secondary Seat Belt Relacement

•	When installing the belt, make sure not to damaged the retractor.

1.	Remove the rear seat. (Refer to Seat & Power Seat - "Rear Seat")

2.	Remove the rear door scuff trim. (Refer to Interior - "Interior Trim")

After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

4.	Remove the clips.

Using a screwdriver or remover, remove the transverse trim (A).

•	When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

6.	After loosening the mounting bolts, then remove the rear seat bracket (A).

7.	Disconnect the lamp (A).

8.	Disconnect the connector (B).

9.	After loosening the mounting screws, then remove the luggage side trim (C).

10.	After loosening the mounting bolt and screws, then remove the rear pillar trim (A).

11.

After loosening the mounting bolts, then remove the rear seat belt (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

12.

Install in the reverse order of removal.

•	Replace ant damaged clips.

Rear Center Seat Belt Retractor

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the roof trim assembly. (Refer to Roof Trim - "Roof Trim Assembly")

After loosening the mounting bolts, then remove the second row center seat belt retractor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Install in the reverse order of removal.

•	Replace any damaged clips.

Rear Seat Belt Buckle Replacement

1.	Remove the rear seat. (Refer to Seat & Power Seat - "Rear Seat")

Loosen the mounting bolt and then remove the seat belt buckle (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

3.	Install in the reverse order of removal.

Front Seat Belt Repair procedures

Replacement Front Seat Belt Replacement [General] • When installing the belt, make sure not to damaged the pretensioner. 1. Remove the following items first : A. ...

Body Electrical System

...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: In car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow air with changing temperature to the in car sensor air inlet. Measure sensor resistance between 1 and 2 terminals. 1. Sensor Ground2. Incar Sensor Signal Specification Temperature [°C(°F)] Resistance between terminals 1and 2 (kx)-20(-4)290.21-10(1 ...

Hyundai Tucson (LM) 2010-2015 Service Manual: External Amplifier Components and Components Location
Components Connector Pin Information No.Connector A (26 pin)Connector B (16 pin)Connector C (12 pin)1Battery +Right surround speaker +Rear right door +2Battery +Left surround speaker +Rear left door speaker +3Battery +-Front right tweeter speaker +4--Front left tweeter speaker +5CAN +-Fron ...