Hyundai Tucson: Engine Control System / Variable Intake Solenoid (VIS) Valve Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Description and Operation

Description

Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table).

Engine condition	VIS valve	Operation
Medium speed	Closed	Increasing engine performance in low engine speed by reducing intake interference among cylinders
Low / High speed	Open	Minimizing intake resistance by shortening intake manifold length and increasing area of air entrance

CVVT Oil Control Valve (OCV) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within the specifi ...

Variable Intake Solenoid (VIS) Valve Specifications

Specification ItemSpecificationCoil resistance (x)30.0 ~ 35.0 [20°C(68°F)] ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Audio Unit Components and Components Location
Components Connector Pin Information No.Connector AConnector B1Rear left speaker (+)CAN High2Front left speaker (+)-3Front right speaker (+)-4Rear right speaker (+)Steering wheel remote5--6-USB D (+)7IgnitionUSB/iPod VDD8Illumination (+)AUX R IN9DetentAUX GND10Rear left speaker (-)Mic (+) B/T11F ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Service Tools Tool (Number and Name)IIIustrationUse09568-34000 Ball joint remover09546-26000 Strut spring compressorCompression of coil spring09568-4R100Lower arm ball joint removerRemoval of front lower arm from front axle ...