Hyundai Tucson: Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	To remove the seat belt anchor pretensioner (C), keep on pushing the lock pins (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

Remove the following parts. (Refer to the Body group- Interior trim)

A.	Door scuff trim

B.	Center pillar trim

4.	Remove the upper anchor bolt.

5.	Disconnect the Seat Belt Pretensioner connector.

6.	Loosen the Seat Belt Pretensioner mounting bolt and remove the Seat Belt Pretensioner.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Install the Seat Belt Pretensioner (BPT) with a bolt.

Tightening torque:

Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the Seat Belt Pretensioner (BPT) connector.

Install the upper anchor bolts.

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Install the following parts. (Refer to the Body group- Interior trim)

A.	Center pillar trim

B.	Door scuff trim

Insert the seat belt to the anchor pretensioner.

Make sure the lock pin is connected in properly.

8.	Reconnect the battery negative cable.

After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Seat Belt Pretensioner (BPT) Components and Components Location

Components ...

Anchor Pretensioner Description and Operation

Description Anchor pretensioner operates as well as belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Steering Angle Sensor Description and Operation
Description The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction and speed of the steering wheel. The HECU uses the signals from the SAS when performing ESP- ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Display Settings
Adjusting the Brightness Press the key Select [Display] Select [Brightness] Use the , buttons to adjust the screen brightness or set the Brightness on Automatic, Daylight, or Night mode. Press the button to reset. 1) Automatic : Adjusts the brightness a ...