Hyundai Tucson: Seat Belt Pretensioner / Anchor Pretensioner Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Restraint / Seat Belt Pretensioner / Anchor Pretensioner Description and Operation

Description

Anchor pretensioner operates as well as belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it is an equipment to make up for the existing short stroke. Anchor pretensioner is supported by two cables and it is an auxiliary equipment to prevent a driver from breaking away doubly as seat belt is being pulled toward anchor side after a collision.

Never measure resistance of anchor pretensioner directly, current of measuring device may cause unexpected airbag deploy.

Seat Belt Pretensioner (BPT) Repair procedures

Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin ...

Anchor Pretensioner Components and Components Location

Components ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling. Compensation Requirement and Procedure 1. Simultaneous replacement of 4W ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Transaxle Control Module (TCM) Repair procedures
Replacement 1. Turn ignition switch OFF. 2. Disconnect the negative (-) battery cable. 3. Remove the battery. (Refer to Engine Electrical System - "Battery") 4. Disconnect the TCM extension connector (A). 5. Remove the TCM (A) after removing the mounting bolts and nut. T ...