Hyundai Tucson: Setup / Sound Settings
Sound Settings
Press the 
key
Select [Sound]
Select [Sound Setting]
Use the 
,
,
,
buttons to adjust the Fader/Balance
settings.
Use the 
,
buttons to adjust the Bass/Middle/Treble
settings.
Press the 
button to reset.
SDVC (Speed Dependent Volume Control)
Press the 
key
Select [Sound]
Select [Speed Dependent Vol.]
The volume level is controlled automatically according to the vehicle speed. SDVC can be set by selecting from Off/Low/Mid/High.
Voice Recognition Volume
Press the 
key
Select [Sound]
Select [Voice Recognition Vol.]
Turn the 
TUNE knob to adjust the
Voice Recognition volume.
Touch Screen Beep
Press the 
key
Select [Sound]
Select [Touch Screen Beep]
This feature is used to turn the touch screen beep on/off.
Blue Link Voice Volume
Press the 
key
Select [Sound]
Select [Blue Link Voice Vol.]
Turn the 
TUNE knob to adjust the
Blue Link Voice Volume.
❈ Blue Link® may differ depending on the selected audio.
Display Settings
Adjusting the Brightness
Press the key
Select [Display]
Select [Brightness]
Use the ,
buttons to adjust the screen brightness
or set the Brightness on Automatic, ...
Clock/Calendar Setting
Clock Setting
Press the key
Select [Clock/Calendar]
Select [Clock Settings]
Use the ,
buttons to set the Hour, Minutes and
AM/PM setting.
✽ NOTICE
Press and hold the key
(ov ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Valve Body Description and Operation
Description
The valve body is essential to automatic transaxle control
and consists of various valves used to control the oil feed from the oil
pump.
Specifically, these valves consist of pressure regulator
valves, oil redirection valves, shift valves, and manual valves. ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Variable Intake Solenoid (VIS) Valve Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
...
