Hyundai Tucson: General Information / Special Service Tools

Special Service Tools
Item
Illustration
Application
Fuel Pressure Gauge
(09353-24100)

Measuring the fuel line pressure
Fuel Pressure Gauge Adapter
(09353-02100)

Connection between the high pressure fuel pump and the fuel feed line
Heated Oxygen Sensor Socket Wrench
(09392-1Y100)

Removal and installation of the heated oxygen sensor

x SST No.09392-2H100 model also can be used for removing the Heated Oxygen Sensor.
Torque Wrench Socket
(09314-3Q100) or
(09314-27130) (19mm)

Removal and installation of the high pressure fuel pipe
Injector Combustion Seal Guide & Sizing tool
(09353-2B000)

Installation of the injector combustion seal
Fuel Pump Locking Ring Remover
(09310-2S200)

Removal and installation of the fuel pump

Specifications
Specifications Fuel Delivery System ItemsSpecificationFuel TankCapacity58x (15.3 U.S.gal., 61.3 U.S.qt., 51.0 Imp.qt.)Fuel FilterTypePaper typeFuel PressureLow Pressure Fuel Line495 ~ 505 kPa ...

Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure to the piez ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Stabilizer Bar Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts when removing the rear wheel & tire. 2. Loosen the nut and then remove the rear stabilizer li ...

© 2010-2020 www.htmanual.net