Hyundai Tucson: Convenient features of your vehicle / Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or  position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection to the position and fan speed control to the lower speed.

OFF mode
Press the OFF button to turn off the air climate control system. However, you can still operate the mode and air intake buttons as long as the ignition switch is in the ON position. ...

Manual climate control system
To defog inside windshield 1. Set the fan speed to the desired position. 2. Select the desired temperature. 3. Press the defrost button ( ). 4. The outside (fresh) air will be selected automatic ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Seal Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) (Refer to Driveshaft and axle - "Front Driveshaft ") 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). 4. Install the oil seal with special service tools.     • Apply lithium t ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Heater & A/C Control Unit(Dual) Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setup temperature display panel every 0.5 second and will show two figures. Codes are displayed in n ...

© 2010-2019 www.htmanual.net