Hyundai Tucson: Windshield Deicer / Windshield Deicer Repair procedures

Inspection
1.
Remove the cowl top cover.
(Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper motor linkage.

3.
Check for continuity between the terminals of deicer lines.

4.
Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.

OK : approx. Battery voltage (12V)

Description and Operation
Description Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module re ...

Windshield Deicer Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the right air vent. (Refer to the BD group - "Crash pad") 3. Remove the windshield deicer switch (A). [LHD] [RHD] ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal [M/T] ECM Terminal Function (M/T) Connector [C200-MA] Pin No.DescriptionConnected to1Injector (Cylinder #3) [High] control outputInjector (Cylinder #3)2Injector (Cylinder #4) [High] control outputInjector (Cylinder #4)3Injector (Cylinder #2) [Low] contro ...

Hyundai Tucson (LM) 2010-2015 Service Manual: PDM Relay Box Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front seat heater switch. (Refer to BE group - "Seat heater switch") 3. Remove the PDM relay box (A) after loosening the screws (2EA) and desconnecting the connector. IG2 Relay Check for continuity between th ...

© 2010-2020 www.htmanual.net