Hyundai Tucson: Blower / Blower Unit Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower unit.
(Refer to Heater - "Heater Unit")
3.
Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.

   
Make sure that there is no air leaking out of the blower and duct joints.
4.
Install in the reverse order of removal.
Blower Unit Components and Components Location
Component Location Components 1. Intake Case (LH)2. Intake Case (RH)3. Blower motor4. Intake door5. Intake actuator6. Mosfet [Auto type]7. Resistor [Manual type]8. Climate control air filter cov ...

Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for prop ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid valve relay should be turned off in case of ESC failure, refer to the ABS fail-safe. 4. ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Driveshaft Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage to the ...

В© 2010-2026 www.htmanual.net