Hyundai Tucson: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a GDS.

Specification: Refer to “Waveform”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.

Crankshaft position sensor installation bolt:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Camshaft Position Sensor (CMPS) Description and Operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Wiper Motor Repair procedures
Inspection Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that the motor operates normally. Replace the motor if it operates abnormally. NoDescriptionNoDescript ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Defogging logic
To reduce the possibility of fogging up the inside of the windshield, the air intake or air conditioning are controlled automatically according to certain conditions such as or position. To cancel or return to the defogging logic, perform the following steps: Manual climate control system ...