Hyundai Tucson: ESC(Electronic stability system) System / DBC Switch Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Brake System / ESC(Electronic stability system) System / DBC Switch Repair procedures

Inspection

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the crash pad side switch assembly. (Refer to Body - "Crash Pad")

3.	Check the continuity between the switch terminals as the DBC switch is engaged.

DBC Switch Description and Operation

Description The DBC function is the acronym word of Downhill Brake Control function. When a vehicle goes down the hill, just pushing the DBC switch enables the car to keep its vehicle's speed a ...

Steering Angle Sensor Description and Operation

Description The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning dir ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Purge Control Solenoid Valve (PCSV) Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in th ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Input Speed Sensor Specifications
Specifications x Type: Hall effect sensor Operation condition (°C)°F((-)40~150)) -40~302Air gap (mm)in.(0.95~1.65) 0.0374~0.0649Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...