Hyundai Tucson: Brake System
- General Information
- Brake System
- Repair procedures
- Brake Booster Components and Components Location
- Brake Booster Repair procedures
- Master Cylinder Components and Components Location
- Master Cylinder Repair procedures
- Brake Line Components and Components Location
- Brake Line Repair procedures
- Brake Pedal Components and Components Location
- Brake Pedal Repair procedures
- Front Disc Brake Components and Components Location
- Front Disc Brake Repair procedures
- Rear Disc Brake Components and Components Location
- Rear Disc Brake Repair procedures
- Parking Brake System
- ESC(Electronic stability system) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- ESC Control Unit Components and Components Location
- ESC Control Unit Repair procedures
- Yaw-rate and G Sensor Description and Operation
- Yaw-rate and G Sensor Repair procedures
- ESC OFF Switch Description and Operation
- ESC OFF Switch Repair procedures
- DBC Switch Description and Operation
- DBC Switch Repair procedures
- Steering Angle Sensor Description and Operation
Anchor Pretensioner Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pin ...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Memory fuse (SHUNT connector)
Your vehicle is equipped with a memory fuse (SHUNT connector) to prevent battery
discharge if your vehicle is parked without being operated for prolonged periods.
Use the following procedures before parking the vehicle for prolonged periods.
1. Turn off the engine.
2. Turn off the headligh ...
Hyundai Tucson (LM) 2010-2015 Service Manual: SRS Control Module (SRSCM) Description and Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints
System Control Module) is to discriminate between an event that warrants
restraint system deployment and an event that does not. The SRSCM must
decide whether to deploy the restraint system or not. After determining
tha ...