Hyundai Tucson: SRSCM / Front Impact Sensor (FIS) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation

Description

The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.

SRS Control Module (SRSCM) Repair procedures

Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Disconnect the DAB, PAB, SAB, CA ...

Front Impact Sensor (FIS) Components and Components Location

Components ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer to “Specification” ETC Motor 1. Turn the ignition switch OFF. 2. Disco ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlight high beams are switched on. WARNING Do not use the high beams when there are other vehicles approaching you. Using high beam could obstruc ...