Hyundai Tucson: Front seats / Manual adjustment

Forward and rearward adjustment

To move the seat forward or rearward:

1. Pull up the seat slide adjustment lever and hold it.

2. Slide the seat to the position you desire.

3. Release the lever and make sure the seat is locked in place. Move forward and rearward without using the lever. If the seat moves, it is not locked properly.

Seatback angle

To recline the seatback:

1. Lean forward slightly and lift up the seatback lever.

2. Carefully lean back on the seat and adjust the seatback to the position you desire.

3. Release the lever and make sure the seatback is locked in place.

(The lever MUST return to its original position for the seatback to lock.)

Front seats
WARNING Take the following precautions when adjusting your seat: NEVER attempt to adjust the seat while the vehicle is moving. The seat could respond with unexpected movement and may cause los ...

Reclining seatback
Sitting in a reclined position when the vehicle is in motion can be dangerous. Even when buckled up, the protection of your restraint system (seat belts and air bags) is greatly reduced by reclini ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Removal 1. Remove the front bumper. (Refer to the BD group - "Front bumper") 2. Remove the bolts and disconnect the horn connectors, then remove the low pitch horn (A). Installation 1. Install the horns after connecting the horn connectors. 2. Install the front bumper. Inspection ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.   ...

© 2010-2019 www.htmanual.net