Hyundai Tucson: Driveshaft and axle / Rear Driveshaft Assembly

Rear Hub - Carrier Repair procedures

Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage to the ...

Rear Driveshaft Components and Components Location

Components 1. Tone wheel2. BJ joint3. BJ boot4. BJ boot big part band5. BJ boot small part band6. Shaft7. TJ boot small part band8. TJ boot big part band9. TJ boot10. Snap ring11. Circlip12. TJ a ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1. Turn the ignition switc ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Hazard warning flasher
The Hazard Warning Flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible. The hazard warning lights are turned on and off by pushing in the hazard switch. This c ...