Hyundai Tucson: SRSCM / Seat Belt Buckle Switch (BS) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation

Description

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Side Impact Sensor (SIS) Repair procedures

Removal Pressure Side Impact Sensor • Removal of the airbag must be performed according to the precautions/procedures described previously. • Before disconnect ...

Seat Belt Buckle Switch (BS) Components and Components Location

Components ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Cowl Top Cover Repair procedures
Replacement 1. Remove the cover and nut, then remove the wiper arm (A). 2. Detach the clips, then remove the cowl top cover (B). 3. Install in the reverse order of removal. • Replace any damage clips. ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Lower Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the rear wheel & tire. 2. Loosen the nut and then remove the rear stabilizer li ...