Hyundai Tucson: Automatic Transaxle Control System / Shift Cable Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable Repair procedures

Removal

1.	Remove the console. (Refer to Body - "Floor console")

2.	Disconnect the shift cable (A) from the shift lever.

Remove the shift cable assembly in the vehicle after removing the nuts (B) and the retainer (A).

Tightening torque :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Remove the nut (C) from the manual control lever.

Tightening torque :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.	Remove the cable (B) from the bracket (A) at transaxle assembly side.

6.	Remove the shift cable by pulling it toward the interior.

Installation

Install in the reverse order of removal.

When installing, Set shift lever and inhibitor switch manual control lever to "N" position.

Adjustment

Adjusting method for T/M control cable

1.	Set room side shift lever and T/M side manual control lever to "N" position.

2.	Connect room side shift lever and shift cable.

3.	Push cable to "F" direction shown to eliminate FREE PLAY.

Tighten adjusting nut (A).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.	After adjusting according check to be sure that this part operates surely at each range of T/M side correspond.

Shift Cable Components and Components Location

Components 1. Shift lever knob 2. Shift lever assembly3. Shift cable4. Manual control lever5. Shift cable retainer ...

4 Wheel Drive (4WD) System

...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Removal 1. Remove the liftgate trim in the trunk after removing the screws and clips. (Refer to the BD group - "Liftgate") 2. Remove the liftgate garnish (A) after disconnecting the connector and removing the nuts. 3. Remove the back view camera (A) after loosening the screws (2EA). ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Door Repair procedures
Replacement Door Trim Replacement • When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Put on gloves to protect your hands. 1. Using a screwdriver or remo ...