Hyundai Tucson: Manual Transaxle Control System / Shift Lever Repair procedures

Removal
1.
Remove the center console.
(Refer to "Console" in BD group)
2.
Remove the snap pin (A) and the clip (B).

3.
Remove the clip (A) and then remove the shift cable assembly.

4.
Remove the shift lever assembly (A).

Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.
Installation is the reverse of removal.
   
•
When installing, set room side shift lever and T/M side lever to "Neutral" position.
•
When installing, adjust the Control cable.
(Refer to "Control Cable adjustment procedure" in this group.)
Shift Lever Components and Components Location
Components 1. Shift lever knob2. Shift lever assembly3. Select cable assembly4. Shift cable assembly ...

Control Cable Components and Components Location
Components 1. Shift lever knob2. Shift lever assembly3. Select cable assembly4. Shift cable assembly ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Starting the engine
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes, such as high heels, ski boots, sandals, flipflops, etc., may interfere with your ability to use the brake, accelerator and clutch pedals.. ✽ NOTICE The engine will start by pressing the Engine Start/Stop ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Hazard Lamp Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the hazard lamp switch assembly. (Refer to the BE group - "Audio head unit") 3. Disconnect the hazard lamp switch connector (A). 4. If the hazard lamp switch is not as specified, replace it carefully and take care n ...

© 2010-2026 www.htmanual.net