Hyundai Tucson: SRSCM / Side Impact Sensor (SIS) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description and Operation

Description

Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).

Side Pressure Sensor is also called P-SIS because that detects pressure due to collision at its mounting location.

Side Impact Sensor is also called A-SIS because that detects acceleration.

SRSCM decides deployment or not of the airbag and the time of deployment through the collision signal of SIS when the collision occurred.

Front Impact Sensor (FIS) Repair procedures

Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor co ...

Side Impact Sensor (SIS) Components and Components Location

Components ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Audio Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the hazard lamp switch assembly (A). Take care not to damage and scratch the hazard lamp switch assembly and its related parts. Apply the protective tapes to the hazard lamp switch assembly and its rel ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Delivery Pipe Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops. 1. Turn the ignition switch OFF ...