Removal |
1. |
Remove the front bumper.
(Refer to the BD group - "Front bumper") |
2. |
Pull out the SPAS sensor (A) by opening the sensor holder out. |
3. |
Disconnect the connector form the sensor. |
1. |
Lift the vehicle up by using Remove the front bumper.
(Refer to the GI group - "Lift And Support Points") |
2. |
Pull out the SPAS sensor (A) by opening the sensor holder out. |
3. |
Disconnect the connector form the sensor. |
1. |
Remove the front bumper.
(Refer to the BD group - "Front bumper") |
2. |
Pull out the SPAS sensor (A) by opening the sensor holder out. |
3. |
Disconnect the connector form the sensor. |
Installation |
1. |
Install the SPAS sensor and connector. |
2. |
Install the front bumper. |
1. |
Install the SPAS sensor and connector. |
1. |
Install the SPAS sensor and connector. |
2. |
Install the front bumper. |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Checking the amount of air conditioner refrigerant and compressor lubricant
WARNING
Because the refrigerant is at very high pressure, the air conditioning system
should only be serviced by trained and certified technicians. It is important that
the correct type and amount of oil and refrigerant is used, otherwise damage to
the vehicle and personal injury may occur. ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specifica ...