Hyundai Tucson: ESC(Electronic stability system) System / ESC Control Unit Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Brake System / ESC(Electronic stability system) System / ESC Control Unit Repair procedures

Removal

1.	Turn the ignition switch OFF.

Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.

Tightening torque :

ABS : 12.7 ~ 16.7N.m(1.3 ~ 1.7kgf.m, 9.4 ~ 12.3lb-ft)

ESC : 18.6 ~ 22.6N.m(1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft)

[LHD]

[RHD]

3.	Pull up the lock of the HECU connector , then disconnect the connector.

Loosen the HECU bracket bolts (A) and nut (B), then remove HECU and bracket.

Tightening torque :

16.7 ~ 25.5N.m(1.7 ~ 2.6kgf.m, 12.3 ~ 18.8lb-ft)

[LHD]

[RHD]

1.	Never attempt to disassemble the HECU.

2.	The HECU must be transported and stored in.

3.	Never shock to the HECU.

Remove the 3 bolts, then remove the bracket from HECU.

Tightening torque :

10.8 ~ 13.7N.m(1.1 ~ 1.4kgf.m, 8.0 ~ 10.1lb-ft)

Installation

1.	Installation is the reverse of removal.

2.	Tighten the HECU mounting bolts and nuts to the specified torque.

3.	After installation, bleed the brake system. (Refer to ABS bleeding)

Variant coding.

2WD and 4WD vehicle are sharing the HECU each other. To apply appropriate vehicle, HECU needs to variant coding process.

Variant coding process is necessary when :

A.	HECU is replaced.

B.	C1702 DTC(variant coding error) code is detected.

Perform the Variant coding.

5.	Perform the Longitudinal Sensor Calibration. (Refer to ESC (Electronic stability system) - "Longitudinal G Sensor")

[Auto Detected Sensor Calibration]

[Hill Start Assist Control Setting]

[Longitudinal G Sensor Calibration]

ESC Control Unit Components and Components Location

Components (1) 1. Front - left tube2. Rear - right tube3. Rear - left tube4. Front - right tube5. MC26. MC17. ESC control module connector8. ESC control module(HECU)9. Damper10. Bracket Componen ...

Yaw-rate and G Sensor Description and Operation

Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Replacement Problems And Replacement Parts: ProblemPart setScan tool requiredxAll keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YESIgnition switch does not workIgnition switch with Antenna coil unitYESUnidentified vehicle specific d ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Power outlet
The power outlets are designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engine running. WARNING Avoid electrical shocks. Do not place your fingers or foreign objects (pin, ...