Hyundai Tucson: Heating and air conditioning / Fan speed control

The ignition switch must be in the ON position for fan operation.

The fan speed control knob allows you to control the fan speed of the air flowing from the ventilation system.

To change the fan speed, turn the knob to the right for higher speed or to the left for lower speed.

Air intake control
The air intake control button is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated ...

To turn off the blowers
Setting the mode selection knob to the “0” position turns off the fan. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Luggage Room Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp (B) when prying the hole (A) with a flat-up screwdriver 3. Remove the luggage room lamp bulb in case of necessity Installation 1. Replace the lamp bulb. 2. Install the luggage room lamp asse ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Driveshaft Components and Components Location
Components 1. Tone wheel2. BJ joint3. BJ boot4. BJ boot big part band5. BJ boot small part band6. Shaft7. TJ boot small part band8. TJ boot big part band9. TJ boot10. Snap ring11. Circlip12. TJ assembly ...

© 2010-2025 www.htmanual.net