Hyundai Tucson: Seats / Headrest
The vehicle’s front and rear seats have adjustable headrests.The headrests provide comfort for passengers, but more importantly they are designed to help protect passengers from whiplash and other neck and spinal injuries during an accident, especially in a rear impact collision.
WARNING
To reduce the risk of serious injury or death in an accident, take the following precautions when adjusting your headrests:
- Always properly adjust the headrests for all passengers BEFORE starting the vehicle.
- NEVER let anyone ride in a seat with the headrest removed.
- Adjust the headrests so the middle of the headrests is at the same height as the height of the top of the eyes (see diagram).
- NEVER adjust the headrest position of the driver’s seat when the vehicle is in motion.
- Adjust the headrest as close to the passenger’s head as possible. Do not use a seat cushion that holds the body away from the seatback.
- Make sure the headrest locks into position after adjusting it.
CAUTION
To prevent damage, NEVER hit or pull on the headrests.
Armrest
The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
You will find cup holders on the center armrest. ...
Front seat headrest
The driver’s and front passenger’s seats are equipped with adjustable headrests
for the passengers safety and comfort.
Adjusting the height up and down
To raise the headrest:
1. Pull ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Cylinder Head Repair procedures
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait until the engine
coolant temperature drops below normal temperature (20°C [68°F])
before removin ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Coolant Repair procedures
Refilling And Bleeding
Never remove the radiator cap when the engine is hot. Serious
scalding could be caused by hot fluid under high pressure escaping from
the radiator.
When pouring engine coolant, be sure to shut the relay box
lid and not to ...
