Hyundai Tucson: Lubrication System / Oil level sensor Repair procedures

Removal and Installation
[For Europe]
When the oil sensor signal fault occurs, refer to the DTC guide.
1.
Drain the engine oil.
2.
Remove the oil level sensor (A) after disconnecting the oil level sensor connector.

Tightening torque:
8.8 ~ 9.8N.m (0.9 ~ 1.0kgf.m, 6.5 ~ 7.2lb-ft)

3.
Installation is reverse order of removal, with a new gasket.
Oil Pressure Switch Repair procedures
Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal ...

Intake And Exhaust System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are cold. “Cold tires� means the vehicle has not been driven for at least three hours or driven less than one mile (1.6 km). Warm tires normally exceed recommended cold tire pressures by 4 to 6 psi (28 to 41 kPa). D ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Smart Parking Assist System Unit Repair procedures
Removal     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Put on gloves to protect your hands. 1. Using a screwdriver or remover, then remove the crash pad ...

© 2010-2026 www.htmanual.net