Hyundai Tucson: Engine Mechanical System / Intake And Exhaust System
- Intake Manifold Components and Components Location
- Intake Manifold Repair procedures
- Exhaust Manifold Components and Components Location
- Exhaust Manifold Repair procedures
- Muffler Components and Components Location
- Muffler Repair procedures
Oil level sensor Repair procedures
Removal and Installation
[For Europe]
When the oil sensor signal fault occurs, refer to the DTC guide.
1.
Drain the engine oil.
2.
Remove the oil level sensor (A) after disconnecting the o ...
Intake Manifold Components and Components Location
Components
1. Intake manifold assembly 2. Intake manifold gasket3. Electronic throttle body4. Electronic throttle body gasket5. Intake manifold stay
...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
Replacing an on/off soleno ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Temperature Control Actuator Description and Operation
Description
1.
Heater unit includes mode control actuator and temperature control actuator.
2.
Temperature control actuator is located at the heater unit.
It regulates the temperature by the procedure as follows. Signal from
control unit adjusts position of temperature door by operating ...