Hyundai Tucson: Lubrication System / Oil Pressure Switch Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Repair procedures

Inspection

1.	Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.

2.	Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.

3.	If there is no continuity when a 50 kPa (0.50 kgf/cmx, 7.25 psi) is applied through the oil hole, the switch is operaing properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Oil Pan Repair procedures

Removal 1. Remove the under covers. (Refer to Engine and transaxle assembly) 2. Drain engine oil. 3. Remove the oil pan (A). (1) Unfasten the bolts. (2) Insert the blade of SST (0921 ...

Oil level sensor Repair procedures

Removal and Installation [For Europe] When the oil sensor signal fault occurs, refer to the DTC guide. 1. Drain the engine oil. 2. Remove the oil level sensor (A) after disconnecting the o ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications Direct control VFS[T/CON] x Control type : Normal low type Control Pressure kpa (kgf/cmx, psi)9.81 ~ 500.14(0.1 ~ 5.1,1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal resistance(x)5.1 ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Fog Lamps Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch. Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the f ...