Hyundai Tucson: Fuses And Relays / PDM Relay Box Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Fuses And Relays / PDM Relay Box Description and Operation

Description

The PDM relay is united with IG1, IG2 and ACC relays and installed beside the assist instrument panel.

ICM (Integrated Circuit Module) Relay Box Repair procedures

Inspection Rear Wiper Relay Check for continuity between the terminals. 1. There should be continuity between the No.11 in the A and No.12 in the A terminals when power and ground are connect ...

PDM Relay Box Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front seat heater switch. (Refer to BE group - "Seat heater switch") 3. Remove the PDM relay box (A) after loose ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications Tightening Torques ItemsN.mKgf.mlb-ftTransfer assembly mounting bolts60.8~65.76.2~6.744.8~48.54WD ECM mounting nuts9.8~11.81.0~1.27.2~8.7Coupling assembly mounting bolts56.9~64.75.8~6.642.0~47.7Propeller shaft mounting bolts49.0~68.65.0~7.036.2~50.6Transfer oil drain plug39.2~ ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Muffler Repair procedures
Removal and Installation Front Muffler 1. Disconnect the front oxygen sensor connector (A) and then remove it from the bracket. 2. Remove the front muffler (B). Tightening torque : 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) When installing, replace wit ...