Hyundai Tucson: Cooling System / Water Temperature Control Assembly Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures

Removal and Installation
1.
Drain engine coolant so its level is below water temperature control assembly.
2.
Remove the air cleaner assembly.
(Refer to Engine transaxle assembly in this group)
3.
Disconnect the radiator upper hose (A).

4.
Disconnect the heater hose (A).

   
When installing the heater hoses, install as shown in illustrations.

5.
Disconnect the bypass hose (A) and the throttle body coolant hose (B).

6.
Remove the water temperature control assembly (A) with the O-ring (B).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Installation is reverse order of removal.
   
•
Install a new O-ring.
•
Clean surface on the O-ring and install the O-ring after wetting with water.
Thermostat Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the thermostat gasket Check the mounting bolts • Check the torque of the mounting bolts • Retighten the bo ...

Lubrication System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Inhibitor Switch Description and Operation
Description Inhibiter Switch contains two contact points. One of these points connects the engine startup when the lever is in the N or P position and turns on the reverse lights. The other contact point monitors the lever's position (PRND) and is used to control gear setting signals. ...

Hyundai Tucson (LM) 2010-2015 Service Manual: ETC (Electronic Throttle Control) System Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

© 2010-2026 www.htmanual.net