Hyundai Tucson: Braking System / Anti-lock Brake System (ABS)
WARNING
Anti-Lock Braking System (ABS) or Electronic Stability Control (ESC) system will not prevent accidents due to improper or dangerous driving maneuvers. Even though vehicle control is improved during emergency braking, always maintain a safe distance between you and objects ahead of you. Always reduce the vehicle speed in extreme road conditions.
The braking distance for vehicles equipped with ABS or ESC may be longer than for those without these systems in the following road conditions:
- Rough, gravel, or snow-covered roads.
- On roads where the road surface is pitted or has different surface height.
- Tire chains are installed on your vehicle.
Never test the safety features of an ABS or ESC equipped vehicle by high speed driving or cornering. It may cause a collision and endanger the safety of yourself or others.
ABS is an electronic braking system that helps prevent a braking skid. ABS allows the driver to steer and brake at the same time.
Warning messages
Parking brake automatically engaged
When EPB is applied while Auto Hold
is activated, a warning sounds and a
message appears.
Press brake pedal to deactivate AUTO
HOLD
If you did not appl ...
Using ABS
To obtain the maximum benefit from
your ABS in an emergency situation,
do not attempt to modulate your brake
pressure and do not try to pump your
brakes. Depress your brake pedal as hard
as ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Function
Bluetooth Audio System
Bluetooth
You can use a Bluetooth device in your car to make a
hands-free phone call or to stream music onto your in-car speakers (via
this Head Unit). This Head Unit supports HFP, A2DP and AVRCP connection.
Advanced Audio Distribution Profile (A2DP)
Th ...
Hyundai Tucson (LM) 2010-2015 Service Manual: PDM Relay Box Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front seat heater switch.
(Refer to BE group - "Seat heater switch")
3.
Remove the PDM relay box (A) after loosening the screws (2EA) and desconnecting the connector.
IG2 Relay
Check for continuity between th ...
