Hyundai Tucson: Warning and Indicator Lights / AUTO STOP indicator light. Turn signal indicator light

AUTO STOP indicator light

This indicator light illuminates:

When the engine enters the Idle Stop mode of ISG (Idle Stop and Go) system.

When the engine automatically starts, the AUTO STOP indicator on the cluster Illuminates to white.

For more information, refer to the "ISG (Idle Stop and Go) system" section in Chapter 6.

Information

When the ISG system automatically starts the engine, some warning lights (ABS, ESC, ESC OFF, MDPS or Parking brake warning light) may turn on for a few seconds because of a low battery voltage but not a system malfunction.

Turn signal indicator light

This indicator light blinks:

When you operate the turn signal lever.

If any of the following occur, there may be a malfunction with the turn signal system.

If any of these occur, have the vehicle inspected by an authorized HYUNDAI dealer.

Downhill Brake Control (DBC) indicator light
This indicator light illuminates: When the ignition switch is in the ON position. The downhill brake control indicator light illuminates for about 3 seconds and then goes off. When yo ...

High beam indicator light. High Beam Assist indicator light. Cruise indicator light
High beam indicator light This indicator light illuminates: When the headlights are on and turn signal lever is moved to high beam position. When the turn signal lever is pulled into ...

Other information:

Hyundai Tucson (NX4) 2022-2023 Owner's Manual: Trailer Towing
Towing a trailer requires experience. The combination of the vehicle and trailer itself is not as responsive as the vehicle by itself. Towing a trailer also requires additional equipment and adequate planning before a trip. Plan your trip according to the speed limits for towing a trai ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Clutch Pedal Repair procedures
Inspection Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measured at the face of the pedal pad.) Standard value Stroke (A): 150 ± 3 mm (5.9055 ± 0.118 in.) Free play (B): 6 ~ 13 m ...

© 2010-2023 www.htmanual.net