Hyundai Tucson: Driver Assistance System / Blind-Spot View Monitor (BVM)

Blind-Spot View Monitor uses the wideside view cameras to display the rear blind spot area of your vehicle on the instrument cluster when the turn signal is turned on.

Information

Refer to the "Driver Assistance Sensors" section in this chapter for the location and the general precautions of wide-side view cameras.

Blind-Spot View Monitor Settings

Blind-Spot View

With the ignition switch ON, go to Setup > Vehicle > Driver Assistance > Blind-Spot Safety > Blind-Spot View (for infotainment system type) from the Settings menu to turn on and off Blind- Spot View Monitor.

Blind-Spot View Monitor Operation

Turns on if:

The left or right side turn signal turns on, the corresponding side view camera image appears on the instrument cluster.

Turns off if:

Blind-Spot View Monitor Malfunction

When Blind-Spot View Monitor is not working properly, have the vehicle inspected by an authorized HYUNDAI dealer.

WARNING

Driver Attention Warning Malfunction and Limitations
Driver Attention Warning malfunction When Driver Attention Warning is not working properly, the "Check Driver Attention Warning (DAW) system" warning message may appear, and the () warnin ...

Cruise Control (CC)
1 Cruise indicator light 2 Set speed Cruise Control allows you to drive at speeds above 20 mph (30 km/h) without depressing the accelerator pedal. ...

Other information:

Hyundai Tucson (NX4) 2022-2023 Owner's Manual: Intelligent Speed Limit Assist Operation
Intelligent Speed Limit Assist may warn and control your vehicle by "Displaying speed limit", "Warning overspeed" , and "Changing set speed". Information Intelligent Speed Limit operation is described based on the offset adjusted to "0". For more information on setting the offset, refe ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Seal Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) (Refer to Driveshaft and axle - "Front Driveshaft ") 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). 4. Install the oil seal with special service tools.     • Apply lithium t ...

© 2010-2023 www.htmanual.net