Hyundai Tucson: Manual Speed Limit Assist (MSLA) / Manual Speed Limit Assist Operation

To set speed limit

1. Press and hold the Driving Assist () button at the desired speed. The Manual Speed Limit Assist () indicator light illuminates on the instrument cluster.

2. Push the + switch up or - switch down to change the set speed.

Push and hold to increase or decrease to the nearest multiple of five (multiple of ten in km/h), and then increase or decrease by 5 mph (10 km/h).

3. Check the set speed limit on the instrument cluster.

If you want to drive over the set speed, depress the accelerator pedal far enough to activate the kickdown mechanism.

The set speed limit blinks and chime sounds until your vehicle speed decreases below the set speed limit.

Information

To temporarily cancel Manual Speed Limit Assist

Press the button to temporarily cancel the set speed limit. The set speed turns off, but the Manual Speed Limit Assist () indicator light stays on.

To resume Manual Speed Limit Assist

Push the +/- switch or button.

If you push the + switch up or – switch down, the set speed is set to the current speed.

If you press the button, the set speed resumes to the previously set speed limit.

To turn off Manual Speed Limit Assist

Press the Driving Assist () button to turn off Manual Speed Limit Assist off. The Manual Speed Limit Assist () indicator light turns off.

Always press the Driving Assist () button to turn off Manual Speed Limit Assist when not in use.

WARNING

To prevent serious injury or death:

Manual Speed Limit Assist (MSLA)
1 Manual Speed Limit Assist indicator light 2 Set speed Manual Speed Limit Assist allows you to set a self-imposed maximum speed limit. If you drive over the set speed, Manual Speed Limit ...

Intelligent Speed Limit Assist (ISLA)
Intelligent Speed Limit Assist uses information of road signs detected from the front view camera and uses the navigation system data to inform you of the speed limit and help maintain within ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Overhead Console Lamp Repair procedures
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp assembly. (Refer to the B ...

Hyundai Tucson (NX4) 2022-2023 Owner's Manual: To temporarily cancel Smart Cruise Control. To resume Smart Cruise Control
To temporarily cancel Smart Cruise Control Press the button or depress the brake pedal to temporarily cancel Smart Cruise Control. To resume Smart Cruise Control Push the +/- switch or button. If you push the +/- switch up or down, your vehicle speed is set to the current speed ...

© 2010-2023 www.htmanual.net