Hyundai Tucson: Maintenance / Owner Maintenance

WARNING

Performing maintenance on the vehicle can be dangerous. If you lack sufficient knowledge, experience, or proper tools and equipment to do the work, we recommend to have it done by an authorized HYUNDAI dealer. Before performing maintenance:

WARNING

Do not touch metal parts (including strut bars) while the engine is operating or hot to prevent serious injury. Turn off the engine and wait until the metal parts cool down before working on the vehicle.

The following lists are vehicle checks and inspections that should be performed by the owner or an authorized HYUNDAI dealer at the frequencies indicated to help ensure safe and dependable operation of your vehicle.

Any adverse conditions should be brought to the attention of your authorized HYUNDAI dealer as soon as possible.

These Owner Maintenance vehicle checks are generally not covered by warranties and you may be charged for labor, parts, and lubricants used.

Owner Maintenance Precautions
Inadequate, incomplete, or insufficient servicing may result in operational problems with your vehicle that could cause vehicle damage or a collision that results in serious injury or death. ...

Owner Maintenance Schedule
When you stop for fuel: Check the windshield washer fluid level. Check for low or under-inflated tires. While operating your vehicle: Note any changes in the sound of the exhaust or ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are cold. “Cold tires” means the vehicle has not been driven for at least three hours or driven less than one mile (1.6 km). Warm tires normally exceed recommended cold tire pressures by 4 to 6 psi (28 to 41 kPa). D ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Parking Assist System Control Unit Specifications
Specifications ItemSpecificationUltrasonic sensorVoltage ratingDC 12 VDetecting range15.7 ~ 47.2 in (400 ~ 1200 mm)Operation voltageDC 9 ~ 16 VOperation currentMAX 300 mAOperation temperature-22°F ~ + 176°F (-30°C ~ + 80°C)Beam widthHorizontal : 100±5°(70cm), Vertical : 60±5°(50cm)Numbe ...

© 2010-2023 www.htmanual.net