Hyundai Tucson: Wipers and Washers / Windshield Wipers

Operates as follows when the ignition switch is turned ON.

MIST: For a single wiping cycle, move the lever up (MIST) and release it. The wipers operate continuously if the lever is held in this position.

OFF: Wipers are not in operation.

INT: Wipers operate intermittently at the same wiping intervals. Use this mode in light rain or mist. To change the speed setting, turn the speed control knob.

LO: The wiper runs at a lower speed.

HI: The wiper runs at a higher speed.

Information

If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed to prevent damage to the wiper and washer system.

AUTO wiper control

The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the interval of the wiping cycle.

To change the sensitivity setting, turn the sensitivity control knob.

If the wiper switch is set in the AUTO mode when the ignition switch is in the ON position, the wiper operates once to perform a self-check of the system. Set the wiper to the OFF position when the wiper is not used.

WARNING

To prevent personal injury:

NOTICE

To prevent damage:

Wipers and Washers
Front windshield wiper/washer Rear windshield wiper/washer A. Wiper speed control (front) ...

Front Windshield Washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. The spray and wiper operation continues until you release the ...

Other information:

Hyundai Tucson (NX4) 2022-2023 Owner's Manual: Additional Safety Precautions
Passengers should not move out of or change seats while the vehicle is moving. A passenger who is not wearing a seat belt during a collision or emergency stop can be thrown against the inside of the vehicle, against other occupants, or be ejected from the vehicle. Do not use any acces ...

Hyundai Tucson (LM) 2010-2015 Service Manual: AUX(Auxiliary) Jack Repair procedures
Removal 1. Remove the floor console upper cover (A) using the appropriate tool. 2. Remove the seat heater switch module (A).     Take care not to damage the hook when removing the switch. 3. Disconnect the connectors (A) from the seat heater switch module. 4. Rem ...

© 2010-2023 www.htmanual.net